©
200423 6-5
Cleaning
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΞΦ95 series
5
- Make sure that during vehicle cleaning no
water enters the air-intake system through
the air intake of the flexible seals of the inlet.
- Do not aim the high-pressure cleaner jet at
the gear lever unit.
- Do not aim the high-pressure cleaner jet
directly at the drive shaft seals, such as the
seals of the spider, intermediate bearing and
sliding joint.
- When the vehicle has been cleaned, it must
be lubricated again with a grease gun or
through the central lubrication system. This
is important because it prevents the
penetration of moisture and dirt at the
various pivots.
To Next Page
Loading...
