EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
3-38
©
200423
Inspection and adjustment
5
ΞΦ95 series
3.40 CHECKING THE GEARBOX FOR LEAKS
1. Visually check the gearbox for leaks.
3.41 CHECKING THE CENTRAL AXLE OF THE TANDEM AXLE UNIT FOR LEAKS
1. Visually inspect the central axle for leaks.
3.42 INSPECTION OF OIL LUBRICATED WHEEL HUBS FOR LEAKS
1. Check the wheel hubs for leaks.
Note:
If leaks occur in the oil lubricated wheel hubs,
the wheel hub should be refilled to the
correct level - once the leak has been
repaired, see chapter: "Draining and filling".
3.43 CHECKING THE GREASED WHEEL HUBS FOR LEAKS
1. Check the wheel hubs for leaks.
Note:
If there are serious grease marks on the brake
disc side of the wheel hub, this could indicate
excessive use of assembly grease on new or
recently assembled wheel hubs.
On wheel hubs that have not been assembled
recently, serious grease marks could indicate a
leak in the seal (1). This means that the entire hub
unit must be replaced.
Serious oil leakage on the driven rear axle hubs
could indicate that the O-ring (2) is not sealing
correctly.
If there is an oil leak the hub unit should be
dismantled to remedy the problem.
To Next Page
Loading...
