©
200423 4-5
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΞΦ95 series
5
4.4 REMOVAL AND INSTALLATION, OIL FILTER ELEMENT
To prevent skin injury, avoid
unnecessary contact with the
drained lubricating oil.
Discard the oil filter element.
Removing the oil filter element
1. Unscrew the cap (2) a few turns and drain
the filter housing. Collect the oil.
2. Remove the cap (2) with the oil filter
element (3) from the filter housing (1) and
then remove the element from the cap.
Fitting oil filter element
1. Fit a new O-ring to the cap (2).
2. Fit the oil filter element with the cap in the
filter housing and tighten the cap to the
specified torque. See "Technical data".
}
4
1
3
2
5
M201049
To Next Page
Loading...
