Chapter 1 General Descriptions
2 BECS-A88/C88 computerized embroidery machine owner’s manual
Notice
Don't jam the vent on the device. Don’t plug up the machine, or it may
set fire.
Notice
Make sure the installation direction is correct.
Notice
Don't expose the machine to humidity gas, poisonous gas, water, and
dust.
Cable Connection
Forbidding
Don't test the insulation of the circuit loop.
Forbidding
Never try to connect overloaded electronic device on the connector.
Notice
Make sure the insulating of the cable is fine.
Notice
Communication cable and power cable should be separated.
Notice
All the cables should be well fixed. Don’t put any strength on cables.
Make sure the turning point of cable is well protected. Add pipes to
increase insulating capability.
Notice
Machine should be grounded. The resistance should be no larger than 10
Ω.
Operation direction
Danger
Don't operating the machine when there is any damage on the surface.
Forbidding
When machine is running, do not touch any running part.
Notice
Make sure the configuration of power supply in normal. Use stabilized
voltage power supply when the voltage rebound is between -10%-10%.
Notice
In case of warning, please check out the problem. Operation can only be
carried out again when problem is solved.
Notice
The power supply has over-currency protection function. There is a
3-mins time lag before the function can be used again.
Maintenance
Warning
If you need to open the machine cover, cut out the power supply first.
Due to the capacitance after power off, operator must wait one minute till
he can open the machine cover.
Notice
Circuit boards can be damaged by static. Non-professional technician
To Next Page
Loading...
Need help?
General
