Chapter 5 Setting General Parameters
BECS-A88/C88 computerized embroidery machine owner’s manual 63
embroider the front cloth-piece again and at this time it’ possible to replace the
back one.
5.2.2
Store Manual Color-changing
In embroidery confirmation status, the user can choose whether to store the
manual color-changing’s needle position into the color-changing order unit. Its
purposes are as follows: 1) If mistakes are found for the automatic color-changing
order in embroidering, the color-changing order can be modified with manual
color-change. 2) When a new design is embroidered with manual color-change
once, the color-change order is set for the design.
To use this function, the user should set the parameter “Store Manual Color” as
“Yes”. Note: the parameter value will automatically change into “No” at the end
of one design embroidering.
5.2.3
Brake Adjustment (A Must for New Machine)
This function is to adjust the control parameters for braking, so as to fit machines
of different mechanical characteristics, which also change with the machine
running. Thus this function can help the machinery parts to work better with the
computer. The function depends on the two parameters “Set Brake Para” and
“Main Motor Para.”.
“Set Brake Para” is to adjust the stop position of the main shaft. When the main
shaft often stops at less than 100 degree, the user can increase the parameter value.
When the main shaft often stops at more than 100 degree, the user can decrease
the parameter value. Thus the user can adjust the value to let the main shaft stop
To Next Page
Loading...
Need help?
General
