Chapter 10 Other Functions
138 BECS-A88/C88 computerized embroidery machine owner’s manual
10.7.3
Factory Customer Change the Password
The factory customer can modify all parameters, before the machine leave factory,
the machine is placed in the appearance of solve the lock. After modify the
password, the machine is placed in lock status, if want to modify the machine
parameter, need to input the password first to make the machine be placed in the
release lock appearance, machine afresh up after give or get an electric and was
placed in the lock appearance again. The concrete process is similar to the process
of administrator release/ change of the process, here no longer give unnecessary
details.
10.7.4
Factory Relieve the Password
The method that the factory relieves the lock is similar to the method that
administrator customer relieves the lock, here no longer give unnecessary details.
10.7.5
The Factory Saves and Recovers Optimize Parameter
The factory customer can save and recover the parameter that was set, the method
is similar with administrator save and recover the parameter, here no longer give
unnecessary details.
10.7.6
The Initialization Parameter of Machine
This function can initialize the general embroidery parameter of the machine. In
the system saved a group of value of default parameter value, the factory and
embroidery factory administrator can save corresponding parameter that they
managed. When use this function to do initialize the parameter, the regularity is as
follows:
To Next Page
Loading...
Need help?
General
