User's Manual
48
Start Time
Configure the start time and end time for the DST.
End Time
NTP Enable the NTP function to sync the Device time with the NTP server.
Server
In the
box, enter the IP address or domain name of the
corresponding NTP server.
Click
, the Device starts syncing with the server
immediately.
Port The system supports TCP protocol only and the default setting is 123.
Interval (Min.)
In the
box, enter the amount of time that you want the Device to
sync time with the NTP server. The value ranges from 0 to 65535.
5.1.4.4 Configuring Network Settings
You can configure the basic network settings such as net mode, IP version, and IP address of the Device.
You can also configure network settings by selecting
Main Menu > NETWORK > TCP/IP.
After you have configured the date and time settings, on the Date&Time interface, click Next.
NETWORK
Configure the settings for network parameters.
Table 5-5 Network settings
Net Mode
: Two Ethernet ports work separately through either of
which you can request the Device to provide the services such as HTTP