Basic Operations 13
Connect your Signage to network by Ethernet and there are two kinds of methods
for you to give an IP to your Signage.
DHCP: When there is a DHCP server in the network, after selecting the DHCP
option, the Signage automatically obtains IP address from the DHCP server.
Static IP: After selecting Static IP, respectively click IP ADDRESS, DEFAULT
GATEWAY or NETMASK, and enter the IP address, default gateway and net
mask according to the network plan.
Connect your Signage to network by Wi-Fi. Click to turn on Wi-Fi first.
Then, to connect your Signage to network, you can:
Click a given Wi-Fi, type its password and click Connect.
Or you can add a Wi-Fi manually: click to display the Add Network
interface. Then type Network SSID and select Security from None, WEP,
WPA/WPA2 PSK and 802.1x EAP. Click Save to finish configuration.
You can connect a 4G mobile network card to your device and select Data
Enabled to finally get your device networked.
Connect your device to VPN. Then your device can get programs from VPN.
4.6.1.2.2 Configuring Whitelist
Configure the IP that are allowed to access the Signage, and only IP addresses in the whitelist
can access the Signage. This is to enhance data security.
In main menu, click Settings > Network Setting > Whitelist. Step 1
The Whitelist interface is displayed.
Click to enable whitelist and make it take effect officially. Step 2
Add an IP address to your whitelist. Step 3
1) Click .
The Add Whitelist interface is displayed. See Figure 4-8.
The add whitelist interface Figure 4-8
2) Type an IP address.
3) Click Confirm.
The IP address you have added is displayed.
Repeat Step 3 to add multiple IP addresses to your whitelist.