Dahua D-PFS4226-24ET-240 - Configuring Port Mirroring

10
Parameter Description
Speed Duplex Setting
Configure the modes of the port speed duplex.
●
Ethernet port.
◇
Auto (default): Auto negotiation mode.
◇
10 M FULL: 10 M full duplex.
◇
10 M HALF: 10 M half duplex.
◇
100 M FULL: 100 M full duplex.
◇
100 M HALF: 100 M half duplex.
◇
1000 M FULL: 1000 M full duplex.
●
Fiber port.
◇
1000 M FULL: 1000 M full duplex.
The port communication can be directly affected if you change the
port speed duplex mode. Please be advised.
Flow Control
Configure the Switch flow control.
●
On: Enable port flow control function.
●
Off: Disable port flow control function.
For Ethernet port, you need to enable port flow control function to
synchronize the inbound speed and the outbound speed to avoid
packet losses.
Step 3 Click
Save
.
4.2 Configuring Port Mirroring
Port mirroring (also called port monitor) is the process of copying the packet of a port or several
ports (called the source port) to another port (called the destination port), which is connected with a
monitoring device for packet analysis. This enables monitoring the network and resolving the
network malfunction.
Step 1 Select
Port Management
>
Port Mirroring
on the
System Info
page.
Step 2 Configure parameters.