Dahua D-PFS4226-24ET-240 - Configuring STP Port

18
page.
Figure 4-2 STP bridge settings
Step 2 Configure parameters.
Table 4-1 Description of the STP bridge settings
Parameter Description
STP Mode
Enable or disable ring network function.
●
When STP is enabled, the Switch cannot be managed through
iLinksView.
●
STP mode and link aggregation function are mutually exclusive. After
configuring link aggregation, STP mode cannot be enabled.
Bridge Priority Set bridge priority. The value ranges from 0 to 61440.
Hello Time
Set the period of root bridge sending BPDU. The time ranges from 1 s to 10
s.
Max Age Set the aging time of current BPDU. The time ranges from 6 s to 40 s.
Forward Delay
After setting topological change, the bridge maintains the time of snooping
and study state. The time ranges from 4 s to 30 s.
Step 3 Click
Save
.
5.1.3 Configuring STP Port
Step 1 Select
Device Management
>
Spanning Tree
>
STP Port Settings
on the
System Info
page.