Dahua D-PFS4226-24ET-240 - Link Aggregation

24
5.2.6 Example of Configuring VLAN
Background Information
Configuration requirements: PC1 and PC4 belong to one department, and PC2 and PC3 belong to
one department. Only PCs in the same department can communicate.
Hardware connection: PC1 connects to port 1 of switch A, and it belongs to VLAN2. PC2 connects to
port 2 of switch A, and it belongs to VLAN3. PC3 connects to port 2 of switch B, and it belongs to
VLAN3. PC4 connects to port 1 of switch B, and it belongs to VLAN2.
Figure 4-9 VLAN networking
Procedure
Step 1 Select
Device Management
>
VLAN
>
Port VLAN Configuration
on the
System Info
page.
Step 2 Configure parameters.
1) Configure port 1 to access port, and it belongs to VLAN2.
2) Configure port 2 to access port, and it belongs to VLAN3.
3) Configure port 3 to trunk port, and it belongs to VLAN2. Configure
Egress Tagging
of
port 3 to
Untag Port VLAN
, and configure
Allowed VLANs
to 2 and 3.
Figure 4-10 Configure port VLAN
Step 3 Click
Save
.
5.3 Link Aggregation
Link aggregation is to form several physical ports of the Switch into one logical port. Several links