12
Figure 3-3 Configure port statistics
Step 2 Select
Counter Mode Selection
, including
Transmit Packet & Receive Packet
,
Collision
Packet & Transmit Packet
,
Drop Packet & Receive Packet
and
CRC (Cyclic Redundancy
Check
)
Error Packet & Receive Packet
, and then view the results.
If there are too many error packets from the port, the working status of the port is very
poor. Make sure to check if there is a problem with the cable connected to the port or the
Switch.
Related Operations
●
Clear statistic results: Click
Clear.
●
Refresh statistic results: Click
Refresh
.
4.4 Configuring Port Speed Limit
You can set port speed limit parameters, and restrict exchanging rate of inbound/outbound data
packets.
Step 1 Select
Port Management
>
Port
Speed Limit
on the
System Info
page.
Step 2 Configure parameters.
To Next Page
Loading...
