User’s Manual
150
Local page
Configure the settings for the local alarms.
Table 5-27 Local alarm settings
Alarm-in Port Select the channel number.
Alarm Name Enter the customized alarm name.
Enable Enable or disable the local alarm function.
Device Type
In the
list, select
or select
as the voltage output
type.
Schedule
Click
to display setting interface.
Define a period during which the motion detection is active. For details,
see "Setting Motion Detection Period" section in "5.10.4.1 Configuring
Motion Detection Settings."
Anti-Dither
Configure the time period from end of event detection to the stop of
alarm.
Alarm-out Port
Click
to display setting page.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
To Next Page
Loading...