User’s Manual
248
More Setting
Show Message: Select the
checkbox to enable a pop-up
message in your local host PC.
Buzzer: Select the checkbox to activate a buzzer noise at the Device.
Video Matrix: Select the checkbox to enable the function. When an alarm
event occurs, the video output port outputs the settings configured in
"
Main Menu > DISPLAY > Tour
."
Not all models support this function.
Send Email:
Enable the system to send an email notification when an
alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > Email
.
Log: Select the checkbox to enable the Device to record a local alarm log.
Extra screen: Select the checkbox to enable the function. When an alarm
event occurs, the extra screen outputs the settings configured in
Main
Menu > DISPLAY > Tour > Sub Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Click OK to save the settings.
On the Wireless Detector page, click Apply to complete the settings.
5.12.2 Configuring Temperature and Humidity Camera
You can view, search and export the temperature and humidity data of camera with such sensors and
configure the alarm event settings.
To use this function, make sure there is at least one camera with temperature and humidity sensor has
been connected to the Device.
5.12.2.1 Enabling Detecting Function
You should enable the IoT function the first time when you enter this page.
On the main menu, select IoT > Management > Temperature/Humidity.
To Next Page
Loading...
Need help?
General