User’s Manual
208
SMD
In the Channel list, select a channel that you want to configure face detection function, and
then enable it.
Configure the parameters.
SMD parameters
Channel In the
list, select a channel to set the motion detection.
Enable Enable or disable the motion detection function.
Sensitivity Set the sensitivity for smart motion detection.
Effective Target Select human or motor vehicle or both.
Schedule Define a period during which the motion detection is active.
Anti-Dither
Configure the time period from end of event detection to the stop of
alarm.
Alarm-out Port
Click
to display setting page.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will be
no delay.
Show Message
Select the
checkbox to enable a pop-up message in your
local host PC.
To Next Page
Loading...
Need help?
General