Local Configurations 60
5.1.4.3 Configuring Date and Time Settings
You can configure the system time, choose the time zone, set the daylight saving time, and
enable the NTP server.
You can also configure date and time settings by selecting Main Menu > SYSTEM >
GENERAL > Date&Time.
After you have configured the general settings, on the General interface, click Next. Step 1
The Date&Time interface is displayed. See Figure 5-20.
Figure 5-20
Configure the settings for date and time parameters. See Table 5-4. Step 2
In the System Time box, enter time for the system.
Click the time zone list, you can select a time zone for the system, and
the time in adjust automatically.
Do not change the system time randomly; otherwise the recorded video
cannot be searched. It is recommended to avoid the recoding period or
stop recording first before you change the system time.
In the System Zone list, select a time zone for the system.
In the Date Format list, select a date format for the system.
In the Date Separator list, select a separator style for the date.
To Next Page
Loading...