Quick Start Guide
5
Select the devices that need initialization, and then click Initialize.
The password setting interface is displayed. See Figure 2-2.
Password setting
Set and confirm the password of the devices, then enter a valid email address, and then click
Next.
The final setting interface is displayed.
Password can be modified or reset in System Settings.
Select the options according to your needs, and then click OK.
The Initialization interface is displayed after initialization is completed. Click the success icon
( ) or the failure icon ( ) for the details.
Click Finish.
The device status in the Modify IP interface (Figure 2-1) turns to Initialized.
Modifying Device IP Address
You can modify IP address of one or multiple devices in one time. This section is based on
modifying IP addresses in batches.
Modifying IP addresses in batches is available only when the corresponding devices have the
same login password.
Do Step 1 to Step 4 in "2.1 Initializing Device" to search devices in your network segment.
After clicking Search setting, enter the username and password, and make sure that they are
the same as what you set during initialization; otherwise there will be wrong password notice.
Select the devices whose IP addresses need to be modified, and then click Modify IP.
The Modify IP Address interface is displayed. See Figure 2-3.
To Next Page
Loading...
Need help?
General
