Dahua ITC231-RF1A-IR - Page 59

Parameter
Note
Prevalue
Brightness Value.
Note: Auto work mode only, and Brightness is selected.
Time Settings
Auto light on time.
Note: Auto work mode only, and Time is selected.
Chart 6-18
6.5.1.7 BW List
6.5.1.7.1 White List
Select Setup>ITC>BW List.
 Enable white list, when system detects vehicle in the white list, barrier is off.
 Set white list match mode.
Figure 6-41
Parameter
Note
Start Match
When checked, set the number of matching characters and the
minimum matching digits. The system will match the license plate as
the white list vehicle without matching each character with the license
plate number which already exists in the white list data.
Card Word
The checked characters are matched, and unselected characters will
not be analyzed.
Min Word
When the number of matched characters meets the value, it is regarded
as white list vehicle regardless of whether other characters match or
not.
Chart 6-19
6.5.1.7.2 White List Search
Search whether a plate of vehicle exits in white list.