Dahua ITC231-RF1A-IR - Page 87

Figure 6-72 Relay Activation
Step 2. Select Enable.
Step 3. Set alarm parameters.
Please refer to the following sheet for log parameter information.
Parameter
Function
Relay-in
Support 2 channels of alarm input.
Period
Set alarm arm and disarm period. Click on setup button to open period menu.
Anti-dither
During anti-dither period, only one alarm will be recorded. Unit is second with range
0s～100 s.
Sensor type
May set NO or NC.
Chart 6-28
Step 4. Select Relay-out accordingly, and set port no. and alarm delay time.
Step 5. Click OK.
6.5.4.1.2 Relay-out