The relay-out interface is shown as in Figure 6-73 Relay-out.
Step 1. Select Setting>Event>Alarm>Relay-out.
Figure 6-73 Relay-out
Step 2. Click 1, 2, or 3. Set 1 channel of alarm output.
Step 3. Click trigger to output alarm signal.
Step 4. Click Refresh to search alarm output status.
6.5.4.2 Abnormity
When the device has abnormality, the system will trigger alarm.
Select Setting>Event>Abnormality, select abnormity tab, see figure shown below.
Figure 6-74 No Storage Card
To Next Page
Loading...