Table 2-1
2.3.4 Baud Rate and Parity Setup
The functions which need to be set between analog speed dome and HDCVI speed dome, which
will be introduced separately.
2.3.4.1 Analog Speed Dome
It is to set parity and baud rate of the speed dome. 5 and 6 bit is the setting bit of parity while 7
and 8 are the setting bit of baud rate, the label is shown in Figure 2-5, please refer to Table 2-2
and Table 2-3 for the setting.
Figure 2-5
Table 2-3
2.3.4.2 HDCVI Speed Dome
It is to set baud rate. 7 and 8 bit is the setting bit of baud rate. The label is shown in Figure 2-6;
please refer to Table 2-4 for the setting.
To Next Page
Loading...
