Figure 2-9
2.4 Reset Button and Micro-SD Card Installation
There is a reset button on the PCB which is located on the speed dome lateral (attached with
label), the DIP switch is shown in Figure 2-10, the switch is moved to ON as 1. Reset button is
used for system reset. As for DIP switch: 1 is the setting bit of 120Ω matched resistance, ON is
to connect to 120Ω matched resistance, 2 is the neutral bit; 1 is the lowest bit and 2 is the
highest bit.
Figure 2-10
To Next Page
Loading...
