The wall shall sustain at least 8X weight of the speed dome.
5.2.2 Installation Steps
Step 1
Take the mounting hole of corner-mounted accessory as template, draw punching location on the
wall with 90° included angle, dig holes and install M8 expansion bolts, use M8 nut to fasten the
corner-mounted pedestal on the wall, which is shown in Figure 5-3.
Figure 5-3
Step 2
Install speed dome, please refer to Figure 5-4 for the installation effect, and refer to “2.5 Speed
Dome Installation” for installation modes.
Figure 5-4
To Next Page
Loading...
