Please refer to the following sheet for detailed information.
Please check the box here to enable email function.
Input server address and then enable this function.
Default value is 25. You can modify it if necessary.
For the server supports the anonymity function. You can auto
login anonymously. You do not need to input the user name，
password and the sender information.
The user name of the sender email account.
The password of sender email account.
System supports SSL/NONE/TLS.
Input email subject here.
System can send out the email of the snapshot picture once
you check the box here.
Input receiver email address here. Max three addresses.
The send interval ranges from 0 to 3600 seconds. 0 means
there is no interval.
Please note system will not send out the email immediately
when the alarm occurs. When the alarm, motion detection or
the abnormity event activates the email, system sends out the
email according to the interval you specified here. This
function is very useful when there are too many emails
activated by the abnormity events, which may result in heavy
load for the email server.
Please check the box here to enable this function.
This function allows the system to send out the test email to
check the connection is OK or not.
Please check the box to enable this function and then set the
corresponding interval.
System can send out the email regularly as you set here.
The system will automatically sent out an email once to test
the connection is OK or not .Before the email test, please
save the email setup information.
3.6.1.1.7 Multicast
The multicast interface is shown as in Figure 3-23.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the same
data packet, multiple-cast is the best option to reduce the broad width and the CPU load. The
source host can just send out one data to transit. This function also depends on the relationship
of the group member and group of the outer.
To Next Page
Loading...