It is to set camera movement direction. There are total 8
directions.
Top/bottom/left/right/top left/top right/bottom left/bottom right.
It is to control speed dome to realize zoom function.
It is to adjust video definition.
It is to adjust brightness.
It is to control PTZ movement speed. It supports value 1 to value
8.
There are 128 presets by default.
You can set camera to a specified preset.
Use direction keys to move the camera to your desired location
and then input preset value. Click Set button, you have set one
preset.
This function allows the camera to move between several presets.
It is to enable horizontal rotate function.
It is to set two limits so that the camera can move back and forth.
The camera can memorize dome operation such as pan, tilt, and
zoom to repeat.
It is to set aux positioning.
4.1.4.1 Preset
This function allows you to set camera to a specified position.
Preset setup
Please note system supports 128 presets by default.
1) In Figure 4-4, use direction keys to move the camera to your desired location.
2) Click dropdown list, select preset; click and click dropdown list. Select number within
1~128.
3) Click to finish the setup.
4.1.4.2 Tour
This function allows camera to go between several presets.
Important
Before you use this function, please set at least two presets.
Tour setup
1) In Figure 4-4, select Tour from the dropdown list and then click button. See Figure 4-6.
To Next Page
Loading...