Dahua SMART PSS - 3.6.2.1 Video Detect

33
Figure 3-31
Please refer to the following sheet for detailed information.
Parameter
Function
Protocol
Select the corresponding dome protocol such as PELCOD.
Address
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Baud
Rate
Select the dome baud rate. Please set according to the speed dome
dial switch setup.
Data Bit
Please set according to the speed dome dial switch setup.
Stop bit
Please set according to the speed dome dial switch setup.
Parity
Please set according to the speed dome dial switch setup.
3.6.2 Event
3.6.2.1 Video Detect
The video detect includes three types:
 Motion detect: Through analyze video, system can enable motion detect alarm when it
detects any moving signal that reaches the sensitivity threshold you set here.
 Video loss: This function allows you to be informed when video loss phenomenon
occurred. You can enable alarm output channel and then enable show message function.
 Camera masking: When someone viciously masks the lens, or the output video is in one-
color due to the environments light change, the system can alert you to guarantee video
continuity.