Dahua SMART PSS - Page 34

30
Watermark
enable
/watermark
character
This function allows you to verify the video is tampered or not.
Here you can select watermark bit stream, watermark mode
and watermark character.
Copy
Click it to copy current setup to other channel(s).
3.6.1.3.2 Snapshot
The snapshot interface is shown as below. See Figure 3-28.
Figure 3-28
Please refer to the following sheet for detailed information.
Parameter
Function
Snapshot type
There are three modes.
 Regular: It enables snapshot function as you set on the
snapshot plan.
 MD: It enables snapshot function when motion detect
occurs.
 Alarm: It enables snapshot function when an alarm occurs.
Image size
It is the same with the resolution of the main stream.
Quality
It is to set the image quality.
Interval
It is to set snapshot frequency.
Copy
Click it; you can copy current channel setup to other
channel(s).
3.6.1.3.3 Overlay
Here is for you to overlay information on the video. See Figure 3-29.