Motion detection function becomes activated in the specified
periods. See Figure 3-33.
There are six periods in one day. You can click to set (Figure
3-34) or use mouse to draw the corresponding period on the time
bar directly (Figure 3-35).
Click OK button, system goes back to motion detection interface,
please click OK button to exit.
System only memorizes one event during the anti-dither period.
The value ranges from 5s to 100s.
There are 10 levels. The sixth level has the highest sensitivity.
You can click this button to set motion detection zone. The
interface is shown as in Figure 3-36. Do remember clicking OK
button to save your motion detection zone setup.
If you select this parameter, then you perform motion detection
alarm recording to this channel.
Please note you need to select auto record in Record-> record
control
System can delay the record for specified time after alarm ended.
Check if to upload to Cloud.
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
System can delay the alarm output for specified time after an
alarm ended.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the centre (Including alarm
centre.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
If you enabled this function, System can send out a message to
specified phone to alert you when an alarm occurs.
You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Here you can set PTZ movement when alarm occurs. See Figure
3-37.
This function is for motion detect only. Check the box here to
To Next Page
Loading...