Please refer to the following sheet for detailed information.
You need to check the box to enable this function.
Please select a channel from the dropdown list.
This function becomes activated in the specified periods.
There are six periods in one day. See Figure 3-39.
There are six periods in one day. You can click to set
(Figure 3-40) or use mouse to draw the corresponding
period on the time bar directly (Figure 3-41).
Click OK button, system goes back to alarm interface,
please click OK button to exit.
System only memorizes one event during the anti-dither
period.
There are two options: NO/NC.
System can delay the record for specified time after alarm
ended.
System can delay the alarm output for specified time after
an alarm ended.
If you select this parameter, then you perform local alarm
recording to this channel.
Please note you need to select auto record in
Record-> record control
Means when alarm link ends, record delay for a certain
period of time before stop.
Enable alarm activation function. You need to select alarm
output port so that system can activate corresponding
alarm device when an alarm occurs.
Check the box here to enable video matrix function.
System can pop up a message to alarm you in the local
host screen if you enabled this function.
Check the box here to enable this function. The buzzer
beeps when an alarm occurs.
System can upload the alarm signal to the centre
(Including alarm centre.
If you enabled this function, System can send out an
email to alert you when an alarm occurs.
If you enabled this function, System can send out a
message to specified phone to alert you when an alarm
occurs.
You need to check the box here to enable this function.
If you select this parameter, then the channel is config
with alarm snapshot function.
Here you can set PTZ movement when alarm occurs.
To Next Page
Loading...