4 Device Configuration
4.1 Device Initialization
It needs to set the user password when logging in for the first time (the username is admin by default). The
figures listed in the following chapter are for reference only. There is difference about interface between
different devices, please refer to the actual device for more details.
Caution
It fails to use device if the device is not initialized.
In order to make sure the device is safe, please keep admin user password well after initialization and
modify it regularly.
It can implement device initialization only when the device IP address (192.168.1.108 by default) and
the PC IP address are in the same network segment.
Step 1
Open IE browser, input camera default IP address in the address bar, and then press Enter.
Note
The factory default IP address is: 192.168.1.108.
The system will display the interface of Device Initialization after it is successfully connected, which is shown
in Figure 4-1.
Figure 4-1
Step 2
Set the login password of admin; please refer to Table 4-1 for more details about the parameters.
The password can be set as 8 to 32 nonblank characters, which can be
made up of number, letter and special character (except “'”,“"”,
“;”,“:”and“&”), and it has to contain at least two types of
characters. Please set the password with high security according to the
password intensity prompt.
To Next Page
Loading...
Need help?
General
