Dahua VTH5341G-W - Page 24

20
Parameter
Description
level, baseband version, Kernel version, build number, and
more) about the indoor monitor.
Tap Network & Internet. Step 3
The Network & Internet interface is displayed.
Tap Ethernet. Step 4
The Ethernet interface is displayed.
Network setting Figure 4-16
Tap Ethernet Ip mode. Step 5
 Select static: Enter IP address, gateway, netmask, and then tap CONNECT.
 Select dhcp: Tap dhcp, the IP information will be automatically acquired.
Wireless network
Tap the Settings icon. Step 1
The network settings interface is displayed.
Tap Network & Internet. Step 2
The Network & Internet interface is displayed.
Tap , the Wi-Fi is enabled. Step 3
Tap , the available wireless networks are displayed. Step 4