Dahua VTH5341G-W - Page 37

33
Parameter
Description
Area
Area numbers. There are 8 areas in total. They cannot be modified.
Type
There are 8 types of alarms: Infrared, gas sensor, smoke sensor, urgency
button, door sensor, stolen, perimeter, and doorbell. Select alarm types
according to detector types.
NO/NC
Select NO (normally open) or NC (normally closed) according to detector
types. It shall be the same as detector type.
Status
There are 5 statuses: instant, delay, bypass, remote, and 24-hour
protection zone.
Instant: In Arm Mode, if you selected this status for an area, once

alarms are triggered, the indoor monitor will give out voice prompt
immediately.
Delay: In Arm Mode, if you selected this status for an area, once

alarms are triggered, the indoor monitor will give out voice prompt a
period later.
Bypass: If you selected the bypass status for an area, after the area

has been armed and alarms are triggered; there will be no voice
prompt. Once the area is disarmed, alarm status will be back to
normal.
Remove: When you select Arm Mode and Disarm Mode for an area

in "at home mode", "away from home mode", "sleep mode", and
"customizable mode", the status of this area will not be changed.
24-hour protection zone: If you selected this status for an area,

whenever alarms are triggered, voice prompt will always be given out.
Enter (Sec.)
In the Arm Mode, after you have selected this status for an area, there will
be no voice prompt when you enter the area from a disarmed area within
the period you set; after that period has passed in the Arm Mode, voice
prompt will be given out.
Exit (Sec.)
In the Arm Mode, after you have selected this status for an area, there will
be no voice prompt unit you have exit the area within the period you set.
After that period has passed in the Arm Mode, voice prompt will be given
out when alarms are triggered.
If you have selected this status for more than one area, and then prompts
of the area with the longest period will be displayed on the indoor monitor.
4.4.5.2 Alarm Output
After you have enabled the alarm output function, when there are people making calls to the
indoor monitor from other devices, alarm devices will send alarms.