Configuration 11
5.3.2 Configuring VTO Number
The VTO number can be used to differentiate each VTO, and it is normally configured
according to building number.
You can change the number of a VTO when it is not working as SIP server.
The VTO number can contain 5 numbers at most, and it cannot be the same as any room
number.
Log in to the web interface of the VTO, and then the main interface is displayed. See Step 1
Figure 5-3.
Main interface Figure 5-3
Select Local Setting > Basic. Step 2
The Device Properties interface is displayed. See Figure 5-4.
Device properties Figure 5-4
In the VTO No. input box, enter the VTO number you planned for this VTO, and then Step 3
click Confirm to save.
5.3.3 Configuring Network Parameters
Select Network Setting > Basic. Step 1
The TCP/IP information is displayed. See Figure 5-5.
To Next Page
Loading...
Need help?
General
