Operating VTO 20
6 Operating VTO
Call Function 6.1
6.1.1 Calling with Room Number
On standby mode, Tap . Step 1
The call interface is displayed.
Enter room number, and then tap Call. Step 2
You will hear the voice message "Calling now, please wait a moment."
During phone call, tap Hangup to end the call. Step 3
6.1.2 Calling with Contact
All the room numbers added to SIP server is displayed in the VTO contact.
On standby mode, tap PhoneBook to view contact. Step 1
Select a contact you need to call, and then tap Call. Step 2
Project Mode 6.2
The project mode is intended for administrators, and administrators can make advanced
configurations to the VTO, including issuing access card, modifying device IP address, and
adding room numbers.
6.2.1 Entering Project Mode
On the standby interface, tap Call and then enter "*+project password+#”, and then you can go
to the project mode. The default project password is 888888, and you can modify it on the VTO
or in the VTO web interface.
6.2.2 Modifying IP Address
In the project mode, select IP Config. Step 1
Enter the planned IP address. Step 2
Tap OK to save the new IP, or tap Cancel to cancel the modification. Step 3
6.2.3 User Registration
Only registered users can unlock doors, so you need to register users.
On the Project Mode interface, select User Registration. Step 1
The User Registration interface is displayed.
To Next Page
Loading...
Need help?
General
