Figure 4- 54
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See
Figure 4- 55. Please make sure your protocol supports this function and you need to use
mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen
to adjust section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ
automatically. The smaller zone you dragged, the higher the speed.
Figure 4- 55
In Figure 4- 54, click to open the menu, you can set preset, tour, pattern, scan and
etc. See Figure 4- 56.
Figure 4- 56
To Next Page
Loading...
Need help?
General