3 Set-up and installation
Installation manual
12
Daikin Altherma ETS(X/H)(B)-D
Heat pump (indoor unit) with integrated heat accumulator
008.1448499_00 – 06/2019 – EN
Fig.3-4 Dimensions, top of unit – type ETS(X/H)B16P50D
Item Designation Item Designation
1 Solar inflow 7 Outdoor unit water inlet
connection
2 Cold water 8 Bivalent feed (type
ETS(X/H)B only)
3 Hot water 9 Bivalent return (type
ETS(X/H)B only)
4 Heating flow
5 Heating return flow A front
6 Outdoor unit water outlet
connection
B rear
Tab.3-1 Legend for Fig. 3-1 to Fig. 3-4
3.2 Transport and delivery
WARNING
When unfilled, the indoor unit is top-heavy and could tip
over during transport. That could put persons in danger or
damage the unit.
▪ Secure the indoor unit well, transport carefully, use the
handles.
The indoor unit is delivered on a pallet. All industrial trucks, such as
lifting trucks and forklift trucks, are suitable for transport.
Scope of delivery
▪ Indoor unit (pre-mounted),
▪ Bag of accessories (see Fig. 3-5),
▪ Document pack.
Fig.3-5 Contents of bag of accessories
A Handles (only required for transport)
B Cover panel
C Hose connecting piece for safety overflow
D Assembly wrench
E Ball valve
F Flat gasket
G O-ring
H Cable tie
I Securing clip
J Venting hose
K Drain hose cover
L Controller rotary switch
M Hood screws
For further accessories for the indoor unit, see price list.
3.3 Installing the heat pump
3.3.1 Selecting the installation site
The installation site of the indoor unit must meet the minimum re-
quirements below (see also Chap. 1.2.3).
Installation area
▪ The base must be level and smooth and have sufficient ground
load-bearing capacity of 1050kg/m² plus safety factor. Install a
pedestal if necessary.
▪ Observe the installation dimensions (see Chap. 3.1).
To Next Page
Loading...
