Daikin Altherma 3 H HT ECH2O Series - Installing the Device

3 Set-up and installation
Installation manual
13
Daikin Altherma ETS(X/H)(B)-D
Heat pump (indoor unit) with integrated heat accumulator
008.1448499_00 – 06/2019 – EN
Minimum distance
DANGER: RISK OF BURNING
The plastic wall of the storage tank on the indoor unit can
melt under the effects of external heat (>80°C) and, in the
extreme case, can catch fire.
▪ Only install the indoor unit at a minimum clearance of
1m from other heat sources (>80°C) (e.g. electrical
heater, oil heater, chimney) and combustible material.
CAUTION
If the indoor unit is not installed at a sufficient dis-
tance below the flat solar panels (the top edge of the stor-
age tank is higher than the bottom edge of the solar pan-
els), the unpressurised solar system in the outdoor area
will not be able to drain completely.
▪ When a solar connection is used, install the indoor unit
low enough under the flat solar panels (observe the
minimum gradient of the solar connection lines).
Recommended minimum distances:
From the wall: (rear) ≥100mm, (sides) ≥500mm
From the ceiling: ≥1200mm, at least 480mm.
Distances from the outdoor unit:
When selecting the installation location, the data in the Tab. 3-2
must be taken into account.
Maximum line length between the indoor and out-
door units
50m
Maximum height difference between the indoor and
outdoor units
10m
Tab.3-2
3.3.2 Installing the device
WARNING
When unfilled, the indoor unit is top-heavy and could tip
over during transport. That could put persons in danger or
damage the unit.
▪ Secure the indoor unit well, transport carefully, use the
handles.
Precondition
▪ The installation site complies with applicable country-specific reg-
ulations and meets the minimum requirements described in
Chap. 3.3.1.
Installation
Fig.3-6 Installing the handles
A Handle
B Cover panel
F Threaded piece
1 Remove the packaging and dispose of it in an environment-
friendly manner.
2 Pull the cover screens off the storage tank (Fig. 3-6, itemB) and
unscrew the threaded fittings (Fig. 3-6, itemF) from the open-
ings at which the handles are to be fitted.
3 Screw the handles (Fig. 3-6, itemA) into the now uncovered
threaded holes.
4 Carefully transport the indoor unit to the installation site, use the
handles.
5 Install the indoor unit at the installation site.