7 Installation
Installer reference guide
46
EBLQ+EDLQ011~016CAV3+W1 + EK(2)CB07CAV3 +
EKMBUHCA3V3+9W1
Daikin Altherma low temperature monobloc
4P522034-1 – 2018.01
X2M
X8M
X2M
X8M
X1M
321
X1M
321
A4PA4P
1 GND
2 L
3 N
2 Fix the cable with cable ties to the cable tie mountings to
ensure strain relief and to make sure that it does NOT come in
contact with sharp edges.
CAUTION
Do NOT push or place redundant cable length in the unit.
7.8.14 To connect the interconnection cable
between option box and control box
1 Connect the connectors from the accessory bag to X5A on A1P
of both the control box and the option box PCB.
2 Connect the connectors by way of a field-supplied cable.
a Connectors (accessory)
b Interconnection cable (field supply)
7.8.15 To connect the electrical meters
INFORMATION
▪ Requires option box EK2CB07CAV3.
▪ To be connected to option box EK2CB07CAV3.
INFORMATION
In case of an electrical meter with transistor output, check
the polarity. The positive polarity MUST be connected to
X2M/7 and X2M/9; the negative polarity to X2M/8 and
X2M/10.
1 Connect the electrical meters cable to the appropriate terminals
as shown in the illustration below.
2 Fix the cable with cable ties to the cable tie mountings.
7.8.16 To connect the alarm output
INFORMATION
▪ Requires option box EK2CB07CAV3.
▪ To be connected to option box EK2CB07CAV3.
1 Connect the alarm output cable to the appropriate terminals as
shown in the illustration below.
2 Fix the cable with cable ties to the cable tie mountings.
7.8.17 To connect the space cooling/heating ON/
OFF output
INFORMATION
▪ Requires option box EK2CB07CAV3.
▪ To be connected to option box EK2CB07CAV3.
1 Connect the space cooling/heating ON/OFF output cable to the
appropriate terminals as shown in the illustration below.
To Next Page
Loading...
