Daikin Altherma EHYKOMB33AA - Room thermostat control - Using the leaving water temperature home pages

4 | Specific installer safety instructions
Installer reference guide
22
EVLQ05+08CA + EHYHBH05A + EHYHBH/X08A + EHYKOMB33AA
Daikin Altherma hybrid heat pump
4P355634-1G – 2022.09
Mounting the outdoor unit (see
"7.3Mounting the outdoor unit"[
4
56]
)
WARNING
Fixing method of the outdoor unit MUST be in accordance with the instructions from
this manual. See "7.3Mounting the outdoor unit"[456].
CAUTION
Do NOT remove the protective cardboard before the unit is installed properly.
Mounting the indoor unit (see
"7.4Mounting the indoor unit"[
4
62]
)
WARNING
Fixing method of the indoor unit MUST be in accordance with the instructions from
this manual. See "7.4Mounting the indoor unit"[462].
Mounting the gas boiler (see
"7.5Mounting the gas boiler"[
4
63]
)
WARNING
▪ ALWAYS fill the condensate trap with water and place it on the boiler before
powering up the boiler. See illustration below.
▪ NOT placing or filling up the condensate trap may cause flue gases to come into
the installation room and can lead to dangerous situations!
▪ In order to place the condensate trap, the front cover MUST be pulled forward or
removed entirely.
Connecting the boiler to the flue gas system (see
"7.6Connecting the boiler to
the flue gas system"[
4
66]
)
WARNING
▪ Make sure that the socket connections of the flue and air supply duct materials
are correctly sealed. Improper fastening of the flue and air supply duct can lead
to hazardous situations or result in personal injury.
▪ Check all flue components for tightness.
▪ Do NOT use screws or parkers to mount the flue system as leakage can occur.
▪ Sealing rubbers can be negatively affected when grease is applied, use water
instead.
▪ Do NOT mix any components, materials or ways of coupling from different
manufacturers.
CAUTION
Read the installation manuals of the field supplied parts.