Why does mist come out of my Daikin D-Series Air Conditioner?
The mist coming out of your Daikin Air Conditioner indoor unit happens when the cold airflow cools the room air, causing it to condense into mist during cooling operation.
Why doesn't hot air flow out immediately from my Daikin D-Series Air Conditioner after starting the heating operation?
The air conditioner is warming up. You should wait for 1 to 4 minutes.
Why does my Daikin D-Series heating stop suddenly with a flowing sound?
The system is likely removing frost from the outdoor unit. Please wait for approximately 4 to 12 minutes.
Why my Daikin D-Series Air Conditioner operation does not start immediately?
If the ON/OFF button was pressed soon after the operation was stopped, or when the mode was reselected, you should wait for about 3 minutes.
Why does my Daikin D-Series Air Conditioner indoor unit smell?
The indoor unit may emit an odor because smells from the room, furniture, or cigarettes are absorbed into the unit and discharged with the airflow. If this occurs, it's recommended to have the indoor unit cleaned by a technician. Consult the service shop where you purchased the air conditioner.
What to do if my Daikin D-Series operation stopped suddenly, but the OPERATION lamp is on?
The air conditioner will automatically resume operation in approximately 3 minutes.
What to do if my Daikin Air Conditioner operation stops suddenly and the OPERATION lamp flashes?
If the lamp continues to flash, it is recommended to contact the service shop where you purchased the air conditioner.
Why does my Daikin Air Conditioner emit water or steam?
In HEAT mode, the frost on the outdoor unit melts into water or steam when the air conditioner is in defrost operation. In COOL or DRY mode, moisture in the air condenses into water on the cool surface of outdoor unit piping and drips.
Why hot air does not flow out soon after the start of heating operation of Daikin Inverter?
You should wait for 1 to 4 minutes after starting the heating operation of your Daikin Inverter.
What to do if my Daikin Inverter operation stops suddenly and the OPERATION lamp flashes?
If the Daikin Inverter stops suddenly and the OPERATION lamp is flashing, clean the air filters or remove any obstacles. After that, turn the breaker OFF, then turn it ON again, and try operating the air conditioner with the remote controller.
General| HSPF Rating | Up to 10.0 |
|---|---|
| Cooling Capacity | 9, 000 - 36, 000 BTU/h |
| Heating Capacity | 9, 000 - 36, 000 BTU/h |
| Energy Efficiency Ratio (EER) | Up to 12.5 |
| Sound Level | 19 - 50 dB (Indoor), 49 - 60 dB (Outdoor) |
| Noise Level | 19 - 50 dB (Indoor), 49 - 60 dB (Outdoor) |
| Power Supply | 208/230V, 1-phase, 60Hz |
Technical specifications for various models, including cooling and heating capacities.
Detailed technical specifications for models in cooling-only mode.
Detailed technical specifications for models in heat pump mode.
Illustrates the wiring connections for PCBs in different unit types.
Wiring diagrams for the outdoor unit's control and inverter PCBs.
Lists connectors and their functions on the outdoor unit's control PCB.
Important precautions and guidelines for diagnosing issues.
How to troubleshoot based on the status of the operation lamp.
Troubleshooting guide for LEDs on SkyAir indoor units.
Troubleshooting guide for LEDs on the outdoor unit.
Troubleshooting guide for LEDs on the BP unit.
To Next Page
