SERVICING
58
COOLING EMERGENCY MODE WIRING FOR TXV
APPLICABLE INDOOR UNIT
Cooling emergency mode is available when using a TXV
applicable indoor unit. To energize the blower at the appro-
priate speed, standard Legacy wiring is required. The image
below shows how the thermostat input terminals are to be
run continuously with this wiring which is required. The out-
door unit will cycle as described in the Cooling Emergency
Mode section when appropriate dip switch modes are set
.
1
2 R
C
G
W1 W2
Y1 Y2
0
DEHUM
Indoor Unit Integrated Control Module
Note: Emergency heating mode is not available with TXV
applicable indoor units. If communications still exist between
the indoor unit and thermostat, the thermostat should be
used to provide heating calls.
To Next Page
