Daikin EHS157034 - After First Commissioning;After Successful Basic; Configuration; Rotary Switch Setting: Configuration

5 x Parameter overview
Daikin RoCon
Daikin Control unit
008.1543999_00 – 03/2017 – EN
Operating instructions
35
5.2 After first commissioning/After successful basic configuration
Tab. 5-2 Parameters in the "Configuration" rotary switch setting
5.2.1 Rotary switch setting: Configuration
Setup LCD Contrast
System Configuration Burner data reset LCD Brightness
Power BIV LCD Illum Time
TDiff-DHW CH Support Language
Equilibrium Temp Date
HT Protect Time
Exp delta WW Keylock Function
BST Control Access Rights
AUX Fct RoCon U1 assign
AUX time Master-RoCon
T-DHW 1 min HZU
Delta-T CH Room thermostat
Max T-HS MF 1 Config
max hysteresis Air Purge
Hysteresis time PWM Config Max Perform Pump
HS off time Min Perform Pump
MaxModgrad DHW
MaxModgrad Heating Sensor Config Outside Config
Min Pressure Outside Temp Adap Storage Config
Max Pressure Terminaladress Exhaust Config
Set Point Pressure System Config MixerConfig
Max Pressuredrop HC Assignment Pressure Config
T-Limit Exhaust
Relay Test
HC Configuration HC Function
DHW Configuration Circl-Pump DHW Pump Mode
Expert Config Max Flow Gradient Circl-Pump Interval T-Outside lim day
Max In/Out Diff Anti-Legionella day T-Outside lim night
Dt Reverse Anti-Legionella time Heat-Slope
Burner Starts Anti-Legionella temp Room Influence
Burner Oper Time DHW Relief T-Room Adj
Parallel DHW T-Flow Day
Lambda-Gx T-HS DHW T-Flow Night
Hysteresis DHW Max T-Flow
Gas type T-Return Max DHW loading time Min T-Flow
Corr qGas start IO-SP DHW Off Time HC Adaption
100% Calibration IO-AV DHW Followup T-Frost Protect
Corr power start ConV Insulation
CL - Offset CES ConF Forced Performance
BCCRe-Update IO-BV IgtoCal Screed
Error Code IO-CalMax Lerr Screed Program
Q-SetpointRoCon IO-Comp PLErr
Q-ActualValueRoCon IO-S Burner Starts
T-HS FI-T Burner Oper Time