5 x Parameter overview
Daikin RoCon
Daikin Control unit
008.1543999_00 – 03/2017 – EN
Operating instructions
37
5.3 Parameter levels for the EHS157068 mixer module
No function when connected to oil and gas-fired heating units.
(Only applicable if the assigned heat generator has a cooling function.)
Tab. 5-12 Parameters in the "Configuration" rotary switch setting
5.3.1 Rotary switch setting: Info
See chap. 5.2.9.
5.3.2 Rotary switch setting: Operating Mode
See chap. 5.2.3.
5.3.3 Rotary switch setting: Set Temp Day
See chap. 5.2.4.
5.3.4 Rotary switch setting: Set Temp Night
See chap. 5.2.5.
5.3.5 Rotary switch setting: DHW Set Temp
No function.
5.3.6 Rotary switch setting: DHW Reheating
No function.
5.3.7 Rotary switch setting: Time Program
See chap. 5.2.7.
5.3.8 Rotary switch setting: Remote Param
See chap. 5.2.8.
5.3.9 Rotary switch setting: Configuration
Setup LCD Contrast
Mixer Config HC Function LCD Brightness
Pump Mode LCD Illum Time
T-Outside lim day Language
T-Outside lim night Date
Heat-Slope Time
Room Influence Keylock Function
T-Room Adj Access Rights
T-Flow Day RoCon U1 assign
T-Flow Night Master-RoCon
Max T-Flow PWM Config Min Perform Pump
HC Adaption Max Perform Pump
T-Frost Protect
Sensor Config Outside Config
Insulation
Outside Temp Adap Flow Temp Config
Forced Performance
Terminaladress
Start T-Out Cooling
Boiler Assignment
Max T-Out Cooling
HC Assignment
T-Flow Cooling start
T-Flow Cooling max
Min T-Flow Cooling
T-Flow Cooling
Cooling Setpoint adj
Relay Test
Screed
Screed Program