General Outline ESIE05-04
1–36 Part 1 – System Outline
1.18 FAQ71B
Outlook and
dimensions
The illustration below shows the outlook and the dimensions of the unit (mm).
Outside line
NOTES
1. Location of unit’s Name
Plate: Right side surface of
casing
2. In case of using wireless
remote controller, this
position will be a signal
receiver. Refer to the drawing
of wireless remote controller
for detail.
hole
(Required space)
50 or more
Approx.
Name plate (Note 2)
Piping
direction
Piping
direction
Piping direction
(Required space)
50 or more
Dimensions for
full open front
panel.
hole
(Piping and
Wiring intake)
Approx.
Approx.
Approx.
Mounting Location
2500 OR MORE
For installation in
high spaces
120 or less
30 or more
(Required space)
50 OR MORE
(Required space)
To Next Page
Loading...
