FTX-N/U, FVXS-N, FDMQ-R Series EDUS091558E
259
C: 3P379751-5D
9
Read Before Operation
Preparation Before Operation
1. Slide the front cover to take it off�
2. Insert 2dry batteries AAA.LR03 (alkaline).
3. Replace the front cover�
To fi x the remote controller holder to a wall
1. Choose a place where the signals reach the
unit�
2. Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the
holder�
3. Place the remote controller in the remote
controller holder�
Fahrenheit/Celsius display switch
Press and (TIMER button)
simultaneously for about 5seconds.
• The temperature will be displayed in Celsius when it is presently displayed in
Fahrenheit, and vice versa.
• The switch operation is only possible when the temperature is being displayed.
Position and
correctly!
+
–
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace bothold batteries together.
• The batteries will last for about 1 year. However, if the remote controller display begins to fade and the possible transmission range becomes
shorter within a year, replace both batteries with new, size AAA.LR03 (alkaline) batteries.
• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Note on remote controller
• Do not drop the remote controller. Do not get it wet.
01_EN_3P379751-5D.indd 9 11/13/2018 2:17:04 PM