388
FTX-N/U, FVXS-N, FDMQ-R Series EDUS091558E
3P363899-2D
r4eOoXal OethoF
1) 2NCEG[QWTƂPIGTUKPVJGKPFGPVCVKQPUQPVJGOCKPWPKV
(one each on the left and right sides), and open the
panel until it stops.
2) Continue to open the front panel further while sliding the
panel to the left and pulling it toward yourself in order to
disengage the rotating shaft on the left side.
To disengage the rotating shaft on the right side, slide
the panel to the right while pulling it toward yourself.
r Installation OethoF
Align the rotating shaft of the front panel with the grooves,
and push all the way in. Then close slowly.
Push both the sides and the center of the lower surface of
VJGRCPGNƂTON[
r Installation OethoF
1) +PUVCNNVJGHTQPVITKNNGCPFƂTON[GPICIGVJGWRRGTJQQMUNQECVKQPU
2) Insert 3 screws of the front grille.
3) +PUVCNNVJGCKTƂNVGTVJGPOQWPVVJGHTQPVRCPGN
< When there is no YorM spaEe DeEause the
unit is Elose to Eeiling >
&KUGPICIGVJGƃCRJQTK\QPVCNDNCFGCPFRWNNVJGNQYGT
part of the front grill toward yourself to remove it.
+HKVKUFKHƂEWNVVQTGOQXGRNCEGDQVJJCPFUWPFGTVJG
center of the front grille, and while pushing up, pull it
toward yourself.
r4eOoXal OethoF
1) Remove front panel.
2) 4GOQXGVJGCKTƂNVGTCPFUVTGCOGTWPKVQPN[HQTOQFGNU
with a streamer unit).
3) Remove the screws (3) from the front grille.
4) &KUGPICIGJQQMUVJGNQECVKQPECPDGKFGPVKƂGFD[
mark) at the top of the grill.
Be sure to wear
protection gloves.
4eOoXal anF Installation of (ront Panel
4eOoXal anF Installation of (ront )rille
CAUTION
Rotating shaft
Push the rotating shaft
of the front panel into
the groove.
1) Push up.
2) Pull toward yourself.
{{{ mark area
(3 locations)
Hook
Push
down.
Hook
Indentations on
the main unit