Daikin FDYM-PV1 User Manual

English 19
5.12 Blow Function Setting
Blow function: After the unit is turned off, water in evaporator of indoor unit will be automatically evaporated to
avoid mildew.
In cooling and dry mode, press Function button till the unit enters dry function, BLOW blinking,
and then press Enter/Cancel button to turn on this function.
In blow mode, press Function button till the unit enters blow function and then press Enter/
Cancel button to cancel this function.
Blow function setting is shown in Fig.5.12
Press “Function” button
into blow function
Press “Enter/Cancel” button
to turn on blow function
Press “Enter/Cancel” button
to turn off blow function
Press “Function” button
into blow function
Turn on the unit, without
turning on blow function
5.12 Blow function settingFig.
Note:
After setting blow function, turn off the unit by pressing 1. On/Off button or remote controller, indoor fan
will run at low fan speed for 10 min. (BLOW shows). Meanwhile, if blow function is canceled, indoor fan
will be turned off directly.
There is no BLOW function in fan or heating mode.2.
01_EN_EM09A058A.indd 1901_EN_EM09A058A.indd 19 5/13/2010 11:43:24 AM5/13/2010 11:43:24 AM

Daikin FDYM-PV1 Specifications

General

Brand	Daikin
Model	FDYM-PV1
Category	Air Conditioner
Language	English