SiBE04-302
Removal Procedure 129
Part 7
Part 7Part 7
Part 7
Removal Procedure
Removal ProcedureRemoval Procedure
Removal Procedure
1. Indoor Unit...........................................................................................130
1.1 Removal of Air Filter.............................................................................130
1.2 Removal of Front Grille ........................................................................133
1.3 Removal of Horizontal Blade and Vertical Blade..................................136
1.4 Removal of Switch Box, PC Board and Swing Motor...........................138
1.5 Removal of Heat Exchanger ................................................................144
1.6 Install of Drain Plug ..............................................................................147
1.7 Removal of Fan Rotor and Fan Motor..................................................148
2. Outdoor Unit........................................................................................152
2.1 Removal of External Casing.................................................................152
2.2 Removal of Bell mouth and Left Side Plate..........................................155
2.3 Removal of PCB and Electrical Box .....................................................156
2.4 Removal of Propeller Fan and Fan Motor ............................................162
2.5 Removal of Compressor Noise Absorption Pad...................................164
2.6 Removal of Partition Plate and Reactor ...............................................166
2.7 Removal of Four Way Valve and Motor Valve .....................................169
2.8 Removal of Compressor.......................................................................172
To Next Page
Loading...
