Daikin FTKM25PVM User Manual

9
Preparation before Operation
To set the batteries
1. Slide the front cover to take it off.
2. Set two dry batteries AAA.
3. Set the front cover as before.
To fix the remote controller
holder on the wall
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3. Place the remote controller in the remote
controller holder.
ATTENTION
About batteries
•
When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
• When the system is not used for a long time, take the batteries out.
• Batteries will last for approximately 1 year. If the remote controller display begins to
fade and the degradation of reception performance occurs within a year, however, replace
both batteries with new size AAA alkaline
batteries.
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
• Never expose the remote cont
roller to direct sunlight.
•
Dust on the signal transmitter or re
ceiver will reduce the sensitivit
y. Wipe off dust with soft cloth.
• Signal communication may be disabled if an el
ectronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room
. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance
to somewhere else, or consult the shop.
Position and
correctly!
+
–
2
3
1
Remote
controller holder
Remote controller
Screws

Daikin FTKM25PVM Specifications

General

Brand	Daikin
Model	FTKM25PVM
Category	Air Conditioner
Language	English