Daikin FTKM25PVM User Manual

14
To start 3-D Airflow
Press the “SWING button ” and the “SWING button ”:
the “ ” and “ ” display will light up and the flap and louvers will
move in turn.
To cancel 3-D Airflow
Press either the “SWING button ” or the “SWING button ”.
COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of “COMFORT AIRFLOW Operation” and
“INTELLIGENT EYE Operation”.
Notes on flaps and louvers angles
• When “SWING button” is selected, the flaps
swinging range depends on the operation mode.
(See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold
air, which tends to collected at the bottom of the
room, and hot air, which tends to collect near the
ceiling, throughout the room, preventing areas of
cold and hot developing.
ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you attempt to
move it forcibly with hand when it is swinging, the
mechanism may be broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
COOL and DRY operation
FAN operation
Lower limit
Upper limit
Stop operation
Stop operation
Upper limit
Lower limit
Comfort airf
low
*
Comfort airf
*Angle of the flap
Model
FTKM25/35/42/50
COOL operation
5° - 40°
DRY operation
5° - 40°
FAN operation
0° - 65°
Comfort airflow
0°
laps
low, Upper limit and Lower limit
please see angles of f
Page 15,16

Daikin FTKM25PVM Specifications

General

Brand	Daikin
Model	FTKM25PVM
Category	Air Conditioner
Language	English